- AT&T Forums Home
- /
- Wireless Forums
- /
- Phones & Devices
- /
- 3G MicroCell™
- /
- Re: Southern California outage?
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
Southern California outage?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
01-27-2011 11:24:49 AM
Anyone else having problems with their MicroCell in Southern California? I'm in West Hollywood, and I noticed my connection went down last night -- the GPS and bars lights were blinking, so I power-cycled the unit before I went to bed. Noticed this morning when I woke up that I still didn't have a connection and the lights were still blinking, so I power-cycled again. Four hours later, same thing.
Re: Southern California outage?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
01-28-2011 03:44:55 PM
I was out for a while yesterday, and am now out again in echo park. typical though. it's either all or nothing for me. obviously my internet is working just fine, as usual.
Re: Southern California outage?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
01-29-2011 11:46:24 AM
I'm out of service, too. I'm in Manhattan Beach, if that matters. I'm really hoping I don't need to perform a "reset" on the device and re-establish the service on my MicroCell account.
Re: Southern California outage?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
01-29-2011 11:53:27 AM
AT&T MicroCell tech support told me that if mine had blinking lights for more than 24 hours after a power-cycle to take it back and get a new unit, since mine had apparently failed to the point of not being able to establish a signal lock. Did that yesterday afternoon. Took home and set up my third MicroCell that is working... for now.








