- AT&T Forums Home
- /
- ConnecTech
- /
- Member Discussions
- /
- General Posts
- /
- Re: Slingbox IR Heads and IP4320
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
Slingbox IR Heads and IP4320
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
05-13-2012 05:13:47 PM
Does anyone know exactly where I need to place the IR blaster heads for the Slingbox on the 4320 box? I am stumped- I have even used a flashlight to locate the little bulb behind the plastic panel on the front but don't see it. I downloaded the Cisco manual and the figure seems to indicate they go right in the middle but there's not a receiver bulb anywhere to be seen. I've moved them around a couple of times but no luck.
The other problem might be that I don't have the right virtual remote- other forums said that it was the same as a couple other models and I've tried those but to no avail. I think my problem is the positioning of the IR blasters but maybe not.
Re: Slingbox IR Heads and IP4320
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
05-21-2012 10:45:37 AM
Hi,
What virtual remote are you using? From what I have read about the product the type of remote is important.
Thank you,
JustinF
I am an AT&T ConnecTech employee and the postings on this site are my own and don’t necessarily represent AT&T’s position, strategies or opinions.
I'm here to help with any technical issues you may have but if you need advanced ConnecTech support over the phone, please visit the
ConnecTech website or call 1-800-344-1734 (Phone support is available 8 am – 11 pm Central Time, 7 days a week)








