- AT&T Forums Home
- /
- U-verse Forums
- /
- U-verse Internet
- /
- Setup and Self-Install
- /
- Question about UVerse install at new house.
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
Question about UVerse install at new house.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
07-10-2012 08:04:47 PM
Hello, I have a question about a new Uverse install.
We are building a new home which will be ready in about 3 weeks. I will have a home office in the downstairs study. I had them wire the study closet with a coax (coming in from garage access point) and 3 CAT 5e cables terminated with RJ45. They were supposed to add a CAT 5e phone line with RJ10 to the closet but it seems they forgot.
I wanted the study closet to be the network access for the whole house. The 3 CAT 5e lines go to the Family room, the game room and to the study where my desk will be. I wanted to have a switch in that closet with the network printer, NAS drive etc. The rest of the house is wired as such: Coax from the garage access point is run to the Family room, the game room, the master bedroom and to the study closet. We have one phone line (CAT5e with RJ10) to the kitchen coming from the garage access point.
My question is this: I am an existing UVerse customer and I would like to transfer my service to this new house. How will a UVerse setup (TV and Internet) work with the configuration I have? Hopefully the above config info is clear...
TIA,
DF








