- AT&T Forums Home
- /
- U-verse Forums
- /
- U-verse TV
- /
- Total Home DVR
- /
- HDMI Error Message H1005
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
HDMI Error Message H1005
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
07-08-2012 10:11:02 AM
Recently I connected the Uverse service, the remote is programmed, and I have good control of TV functions. But when I turn it off, and switch it on again with the DVR, you see the message "HDMI Error H1005."
Apparently, the DVR does not recognize the TV at the time of turned on, because the TV takes a few seconds to connect to the DVR.
If I program the control to turn on separately, and first I do with the TV and then the DVR, everything works perfectly, but if the cycle is reversed, the message appears again.
Is there a way to program the DVR to be delayed a few seconds to turn on and that way recognize the TV?
Re: HDMI Error Message H1005
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
07-16-2012 03:05:01 PM
In efforts to avoid board clutter and confusion, we ask that you please refrain from cross and double posting. Please check here for responses to your inquiry. Thank you.
Remember to always mark items that you find useful as "Accepted Solutions”, you can even mark multipleposts in a single thread. This will help other users find this information too!!








